Wire Harness Rev. 2 Nozzles Red Nozzle 400fps - 485fps

Red Nozzle 400fps - 485fps w/

This valve is specifically made for the PolarStar Fusion Engine and has higher wattage coils and tighter seals than an off-the-shelf MAC 33A valve

You can visually inspect the nozzle by peering down the muzzle with flashlight (first making sure the rifle is unloaded and air is disconnected) and seeing if the gap visible around the nozzle is equal on all sides

5 micron filter and check valve to prevent liquid CO2 from entering the regulator regardless of the rifle's orientation and therefore safeguarding the system from any spikes in pressure

Wire Harness Rev. 2 Nozzles Red Nozzle 400fps - 485fpsThe PolarStar wire harness is constructed with 24 AWG wire for superior continuity and features a nylon mesh sheath to protect the wires as they pass through the replica's body. These harnesses are universally compatible with all PolarStar electro pneumatic HPA systems excluding the original V2 GEN1 Fusion Engine and Amoeba kits. Compatible with any PolarStar system that uses a REV2 or REV3 FCU. 18" is standard length for V2 kits in F2, F1 and JACK.